Rectangular White Ceramic Wall Mounted or Drop In Sink

Yes, as this item as pre-drilled holes for wall mount installation, there will be two holes on the back of the sink. Please see attached photo, as the back of the sink would show certain elements if not wall mounted.

This is referring to the wall mounted side of this sink. Though, the bottom will be glazed in visible areas, it will not be glazed in its' pitted areas (the X sections pictured below).

Yes, the "no hole" is referencing that there will be no faucet hole on the sink; a wall mount or countertop faucet would be installed with a no hole sink. The sink will still include the overflow hole.

When it comes to mounting brackets, we do not supply or sell these. However, you can purchase a mounting bracket from a local hardware store, though the bolts supplied are more than capable when properly installed. Attached below are installation instructions and materials included:

The mounting hardware included with the sink is two 8 mm bolts with corresponding nuts, washers and plastic sleeves. This will hold and install the sink securely. If you would like additional support, brackets can be purchased at a local hardware store.

- To mount the sink onto the wall, you must locate studs in the wall and drill holes into the wall for the corresponding bolts. If the studs in the wall do not line up with the pre-drilled holes in the sink, you may secure a piece of wood with angled screws to the studs so that the holes will line up properly and ensure the stability of the mounting.
- The bolts will thread through the holes already drilled in the sink and into the wall.
- The bolt side will thread through the sink and secured with washers and nuts.
- The screw side of the bolt will go into the plastic sleeves and into the wall.

Unfortunately, this faucet hole can only be drilled as positioned in the photo shown. The back of the sink will also have a little bit rougher of a ceramic showing in the front, not completely glazed like the front and sides.